CAM350 Basic Mouse Control and GUI - 3:41 minutes

This video shows how to use a mouse in CAM350. The GUI is also discussed as well as how to customize it. Custom toolbars and hot keys are demonstrated

Loading Gerber, NC, IPC-d-356 and ODB++ files into CAM350
- 4:17 minutes

This video shows how to load Gerber, NC, IPC-d-356, and ODB++ files into CAM350.

Editing Data in CAM350 - 3:44 minutes

This Video show how to do edits such as copy, move, delete in CAM350. It shows how to do multiple selects, so the multiple items can be edited at one time.

How to Compare Two Designs in CAM350 - 4:13 minutes

This video shows how to compare two designs using Streams RC in CAM350.

Streams Rule Checking in CAM350 - 5:14 minutes

This video shows Stream's RC in CAM350. A design is completely analyzed using a checklist of issues that might prevent successful manufacture of the design.

Netlist Compare in CAM350 and StreamsRC - 2:30 minutes

This video shows how to run a netlist comparison in CAM350 and the Stream's RC checklist.  Gerber and IPC files are loaded, and CAM350 extracts a netlist from the gerber files and comapres to the ipc-d-356 netlist.

Design Analysis in CAM350 and Allegro or OrCad PCB Editor
- 5:24 minutes

This video shows the three options for running draw to flash in CAM350 - interactive, interactive any angle, and automatic.

Draw to Flash in CAM350 - 3:34 minutes

This video shows the three options for running draw to flash in CAM350 - interactive, interactive any angle, and automatic.

Fast Array Module in CAM350 - 2:24 minutes

In this Video, we create an assembly panel in CAM350 using the Fast Array Module.

Creating a Fabrication Panel in CAM350 - 5:34 minutes

In this Video, we create a Fabrication Panel in CAM350. Complete with step and repeat, coupons, and Venting/Thieving patterns.

NC Editor in CAM350 - 3:59 minutes

In this Video, We take a look at the NC editor in CAM350 , and how to create an Mill program.